Precor Adjustable Cable Crossover


3,280 KD

The 407B Adjustable Cable Crossover is a stand-alone cable crossover machine with two adjustable high/low pulley stations and a connector that offers dual chin-up bar options. The Crossover adjusts quickly to give users a wide range of exercise options.

Equipment Features

Upholstery:  Premium-quality upholstery with Beautyguard protective topcoat finish. Fabric meets or exceeds California fire regulations (Bulletin 117, section E). Double-layer slipcover in appropriate high wear areas. Double stitching on all seams.
Bolts: Grade 5 black zinc in most applications.
Cable Routing:  Wherever possible, redirection pulleys are used to route cables close to the frame to minimize the chance of external interference.
Handles:  Slip-resistant rubber sleeve with machined alloy end-cap.
Weight Stack:  On most selectorized units, the weight stack is elevated 5 inches to facilitate user pin selection from seated position.
Selector Plates:  Each selector plate entirely precision machined on all surfaces. The top plate has replaceable Igus precision self-lubricating bushings. Black painted protective finish.
Pivot Points and Joints:  Pillow block or flange-mount motor-grade rotary bearings or sleeve bearings utilizing either oil-impregnated bronze bushings or pre-lubricated Igus nylon bushings.
Pulleys and Cables:  Glass-fiber-reinforced nylon pulleys with precision motor-grade ball bearings. 3/16-inch (7x19) aircraft cable coated with black pressure-extruded nylon to 1/4 inch or 1/8 inch coated to 3/16 inch. The cable will conform to specification MIL-W-83420D-BARE cable only. Attachments are climbing-rated carabiner design.
Frame and Finish:  11 gauge (.120") and 7 gauge (.188") 2x4-inch bent electroweld steel tubing. Minimum of 3 standard bolt tabs on appropriate units. Abrasive grit pre-finish is followed by electrostatically applied, heat-cured powder coat.
Guide Rods:  Guide rods are precision centerless ground, polished, with corrosion-resistant plating for smooth operation and retardation of rust.
Bearings and Pivot Points:  Oversized linear reticulating ball bearings are self-aligning, sealed and running on case-hardened shafts.

Equipment Specifications

Weight Stack Standard:  150 lbs / 68 kg
Options:  Rubber Feet Standard Shroud
Weight Stack Heavy:  200 lbs / 91 kg

Weight Stack: 

Depicted weight stack shrouds are not available

Equipment Dimensions and Weight

Length: 176 inches / 447 cm
Width: 43 inches / 109 cm
Equipment Weight:  870 lbs / 396 kg
Height 91 inches / 231 cm


You may also like

Recently viewed